| 413 |
5782d 01h |
jelle |
/trunk/working/gschem/ |
updating all schematics with new footprints references and bumped up data and version |
|
| 262 |
5966d 00h |
jelle |
/trunk/working/gschem/sch/ |
updating symbols with new footprint and device information |
|
| 241 |
5979d 01h |
jelle |
/trunk/working/gschem/ |
create sch directory and move, rename and renumber all sub schematics |
|
| 219 |
5998d 22h |
jelle |
/trunk/working/gschem/ |
adding testpoints and not connected symbols to all schematics, also replaced most input and output sympols with normal nets, when the signal is not used outside the schematics, so a lot of small cleanups, and some symbols are replaced |
|
| 174 |
6029d 00h |
jelle |
/trunk/working/gschem/ |
adding title box to all schematics |
|
| 170 |
6029d 05h |
jelle |
/trunk/ |
adding README and PLANNING additions, see the open for contribution requests :-p |
|
| 167 |
6029d 20h |
jelle |
/trunk/working/gschem/ |
adding to logic ic's schematics and makefiles for the SN74LVC2G07 and SN74LVC1G08 |
|
| 158 |
6049d 02h |
jelle |
/trunk/working/gschem/ |
updating schematics |
|
| 124 |
6050d 05h |
jelle |
/trunk/working/gschem/ |
updating power-on-reset schematic and drc check, need two new symbols for ic's |
|
| 115 |
6054d 18h |
jelle |
/trunk/working/gschem/ |
adding reset button and logic to the power-on-reset schematic |
|
| 111 |
6056d 03h |
jelle |
/trunk/working/gschem/ |
found out that the reset_n input pin was powered by the +1.2V core power not the +3.125 IO power |
|
| 107 |
6056d 16h |
jelle |
/trunk/working/gschem/ |
fixing some mistakes in the schematics |
|
| 106 |
6056d 17h |
jelle |
/trunk/ |
aligning all the power nets to the correct value |
|
| 102 |
6056d 17h |
jelle |
/trunk/working/gschem/ |
adding initial power-on-reset schematic |
|