OpenARM Single-board Computer - /trunk/working/gschem/power-on-reset.sch

Rev 124 -- updating power-on-reset schematic and drc check, need two new symbols ...

jelle — Wed, 20 Aug 2008 11:12:12 +0200

jelle -- 2 file(s) modified
updating power-on-reset schematic and drc check, need two new symbols for ic's

~ /trunk/working/gschem/power-on-reset.drc
~ /trunk/working/gschem/power-on-reset.sch

jelle — Fri, 15 Aug 2008 21:49:00 +0200

jelle -- 1 file(s) modified
adding reset button and logic to the power-on-reset schematic

~ /trunk/working/gschem/power-on-reset.sch

jelle — Thu, 14 Aug 2008 13:37:07 +0200

jelle -- 1 file(s) modified
found out that the reset_n input pin was powered by the +1.2V core power not the +3.125 IO power

~ /trunk/working/gschem/power-on-reset.sch

jelle — Wed, 13 Aug 2008 23:39:01 +0200

jelle -- 2 file(s) modified
fixing some mistakes in the schematics

~ /trunk/working/gschem/openarm-project.prj
~ /trunk/working/gschem/power-on-reset.sch

jelle — Wed, 13 Aug 2008 23:10:24 +0200

jelle -- 3 file(s) modified
aligning all the power nets to the correct value

~ /trunk/doc/POWER/LD1117STR/information.txt
~ /trunk/working/gschem/power-on-reset.sch
~ /trunk/working/gschem/power-supply.sch

jelle — Wed, 13 Aug 2008 22:44:11 +0200

jelle -- 3 file(s) modified
adding initial power-on-reset schematic

~ /trunk/working/gschem/gschem.log
+ /trunk/working/gschem/power-on-reset.drc
+ /trunk/working/gschem/power-on-reset.sch